IBM eServer xSeries 235 Type 8671 Option Installation Manual page 59

6. If the second microprocessor socket is covered with protective film, peel and
remove the film.
Heatsink 2
Microprocessor 2
Microprocessor
baffle
7. Install a VRM in the corresponding VRM connector (J1):
a. Center the VRM over the connector. Make sure that the VRM is oriented
and aligned correctly.
b. Carefully but firmly push down the VRM clip handle to seat the VRM in the
connector.
c. Make sure that the VRM clip locks on the VRM connector at both sides.
CAUTION:
You must lift up the microprocessor-release lever before inserting the
microprocessor into the socket. Inserting the microprocessor into the
socket without lifting up the microprocessor-release lever can damage
the microprocessor and system board.
8. Install the microprocessor:
a. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the server; then, remove the
microprocessor from the package.
b. Pull out and lift up on the microprocessor-release lever to unlock the
microprocessor socket.
c. Center the microprocessor over the microprocessor socket. Align the
triangle on the corner of the microprocessor with the triangle on the corner
of the socket and carefully press the microprocessor into the socket.
Captive screws
VRM 2
Microprocessor-
release lever
DIMMs
Chapter 2. Installing options
47