Turning Off The Server - IBM eServer xSeries 235 Type 8671 Option Installation Manual

Turning off the server

Turning off the server refers to the act of disconnecting the server from the power
source.
Complete the following steps to manually turn off the server:
1. Review the information in "Safety" on page v.
2. See your operating system documentation for the proper procedure to shut
Statement 5
CAUTION:
The power-control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
3. Press the power-control button on the front of the server. This will put the server
4. Disconnect the server from the power source.
12
IBM xSeries 235 Type 8671: Option Installation Guide
down the operating system.
in Standby mode.
Note: You might need to press and hold the power-control button for more than
4 seconds to cause an immediate shutdown of the server and to force it
into Standby mode. You can use this feature if the operating system
stops functioning.
Note: After disconnecting all the power cords, wait approximately 15 seconds
for your system to stop running. Watch for the power-on LED on the front
of the server to stop flashing.