IBM eServer xSeries 235 Type 8671 Option Installation Manual page 66

54
IBM xSeries 235 Type 8671: Option Installation Guide
c. Disconnect the other device power connectors (P4 and P6) from the rear of
any other devices in the server.
d. Disconnect the SCSI cable (P2) from the SCSI backplane.
e. Disconnect the power cable (P1) from the J4 connector on the system
board.
f. Disconnect the power signal cable (P3) from the J10 connector on the
system board.
g. If your server has the 3-Pack Ultra320 Hot-Swap Expansion option
installed, disconnect the power connector (P8) from the power connector
on the 3-Pack backplane.
5. Remove the fixed power supply (see the following illustration).
a. From the rear of the server, remove the two screws at each side of the
fixed power supply.
b. Gently pull the power supply from the server, making sure the cables do
not snag on the chassis or system board.
Note: You might need to insert a fingernail or screwdriver blade behind
one corner of the power supply to begin moving it.
Attention: When installing the power supply, do not pull it into position by its
cables.