Installing A Hot-Swap Hard Disk Drive - IBM eServer xSeries 235 Type 8671 Option Installation Manual

Installing a hot-swap hard disk drive

The following illustration shows how to install a hot-swap hard disk drive.
Complete the following steps to install a drive in a hot-swap bay.
Attention:
than 10 minutes without either a drive or a filler panel installed for each bay.
Note: All hot-swap drives being used in the server should have the same
1. Review the information in "Safety" on page v, "Installation Guidelines" on page 9,
2. Remove the filler panel from one of the empty hot-swap bays.
3. Install the hard disk drive in the hot-swap bay:
To maintain proper system cooling, do not operate the server for more
throughput speed rating; mixing speed ratings might cause all drives to
operate at the lower throughput speed.
and "Handling static-sensitive devices" on page 10.
a. Ensure that the tray handle is open (that is, perpendicular to the drive).
b. Align the drive assembly with the guide rails in the bay.
c. Gently push the drive assembly into the bay until the drive stops.
d. Push the tray handle to the closed (locked) position.
e. Check the hard disk drive status indicator to verify that the hard disk drive is
operating properly.
If the amber hard disk drive status LED for a drive is lit continuously, that
drive is faulty and needs to be replaced. If the green hard disk drive activity
LED is flashing, the drive is being accessed.
Note: If your server is configured for RAID operation using the integrated SCSI
controller with RAID capabilities or an optional ServeRAID controller, you
might need to reconfigure your disk arrays after installing hard disk
drives. See the ServeRAID documentation on the IBM ServeRAID
Support CD for additional information about RAID operation and
complete instructions for using ServeRAID Manager.
Slim
filler panel
Hard disk drive
Drive tray
Drive tray handle
(in open position)
Chapter 2. Installing options
39