IBM eServer xSeries 235 Type 8671 Option Installation Manual page 65

Notes:
1. During normal operation, both hot-swap power-supply bays must have power
supplies installed for redundancy.
2. Two cable-restraint brackets are on the rear of the tower model servers. After
you install the hot-swap power-supply option and connect the cables to the
selected devices, you can use these cable-restraint brackets to manage the
cable routing. Route the power cords through the power-cord restraint bracket
on the bottom. Route the remaining cables (for example, the cables that are
connected to the I/O ports) through the I/O cable-restraint bracket on the top.
If you install or remove a power supply, observe the following precautions.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that
has this label attached. There are no serviceable parts inside these components. If you
suspect a problem with one of these parts, contact a service technician.
Complete the following steps to remove the fixed power supply and install the
hot-swap power-supply option.
Note: If your server is a tower model, you might find it easier to install the
hot-swap power-supply option if you turn the server on its side so that the
power supply is on the bottom.
1. Review the information in "Safety" on page v, "Installation Guidelines" on
page 9, and "Handling static-sensitive devices" on page 10.
2. Turn off the server and disconnect all power cords and external cables
("Turning off the server" on page 12); then, remove the server cover (see
"Removing the server left-side cover and bezel (tower model)" on page 15 or
"Removing the server top cover and bezel (rack configuration)" on page 17).
3. Remove the adapter-support bracket. See "Removing and installing the
adapter-support bracket" on page 19 for instructions.
4. Disconnect the power-supply cables from the system board and devices in
your server.
a. Disconnect the small-device power cable (P7) from the back of the diskette
drive.
Note: You might need to remove the diskette drive from the server in order
to disconnect and reconnect its cables. The diskette drive is held in
the server by release tabs that are accessed by removing the server
front bezel.
b. Disconnect the device power connector (P5) from the back of the CD-ROM
drive.
Chapter 2. Installing options
53