Mazda 6 Training Manual page 209

FRONT SEAT
Outline
• Three types of seats are available.
— Manual seat with seat lifter (Driver’s side)
— Manual seat without seat lifter (Passenger’s side)
— Power seat (Driver’s side)
• A lumber support has been adopted for driver’s seat.
• The function and operation of the power seat is basically the same as the current MELLENIA (TA) model.
Structural View
.
1 Power seat (Driver’s side)
2 Manual seat with seat lifter (Driver’s side)
3 Manual seat without seat lifter (Driver’s side)
4 Slide motor (With power seat)
5 Rear tilt motor (With power seat)
End Of Sie
REAR SEAT
Outline
• An easy fold-down function has been adopted.
• Child restraint seat anchors have been adopted. There are two types of anchors used for child restraint
systems: the ISOFIX and tether strap anchors.
Caution
• • • • Installation procedure varies with the type of child restraint seat. When installing a child restraint
seat, be sure to follow the prescribed procedure for each type.
• • • • A child restraint seat using a tether strap cannot be completely secured with only the tether strap.
Use an ISOFIX anchor, or a rear seat belt in conjunction with the anchor used with the tether strap.
S–18
SEAT
6 Front tilt motor (With power seat)
7 Recliner motor (With power seat)
8 Power seat switch (With power seat)
9 Lumber support lever (Driver’s side only)
10 Seat lifter lever (Driver’s side only)
A6E775257100T03
A6E7752T002
A6E775257200T01