Ricoh G165 Service Manual page 250

Fusing and Exit
[A]: Idling ready temperature (100°C)
The fusing unit starts to rotate (idling) for 54 seconds [a].
[B]: Print ready temperature (170°C)
This is the temperature to wait for a print job [b].
[C]: Target temperature after 1st print (This depends on the target temperature of each
paper type; see the table below)
The machine keeps this temperature for printing (c) after the 1st print time (d: 14
seconds).
[D]: First print temperature (target temperature + 10°C)
The machine keeps this temperature for the first printing time (d: 14 seconds).
[E]: 10 seconds recovery temperature (155°C)
This is the low power mode for printing. This temperature is lower than the target
temperature [C] and saves power. This mode is adjustable (default: 15 minutes) with
the "Power Saver" setting in the user mode.
[F]: Sleep mode
The machine turns off power to the engine unit for sleep mode after the machine has
not received a print job for 15 minutes.
G165/G166/G167/G181/G183/G184 6-42 SM