Ricoh G165 Service Manual page 193

Dial Pulse Setting Dial Pulse Type
Tone Signal
Transmission
Time Length
Minimum Pause
In Tone Dialing
Attenuator For
Pseudo Ring
Tone Signal
Back tone To
Settings
the Line
DTMF Level
DTMF Delta
1Dial Tone
Wait Time
Detection
SM
This sets the number of pulses that are generated
during dialing.
N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 9 pulses.
N+1: Dialing '0' generates 1 pulse --- Dialing
'9' generates 10 pulses.
10-N: Dialing '0' generates 10 pulses ---
Dialing '9' generates 1 pulse.
Sets the tone signal transmission time length
[100 ms (Default)]
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Sets the attenuator for pseudo ring back tone to
the line
[0 to 15 / 10 (Default)/ 1 dB/step]
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]
Sets the level difference between high band
frequency signals and low band frequency signals
when sending DTMF tones.
[2 dBu/ 3 dBu]
The machine starts dialing after the specified
interval without detection of a dial tone when
Dial tone detection is set to "No detection."
[3.5 Sec (Default)/ 7.0 Sec/ 10.5 Sec
/ 14.0 Sec]
5-45 G165/G166/G167/G181/G183/G184
Service Menu (MF Model)