Table of Contents
Advertisement
Understanding the printer menus
Use
Baud
1200
2400
4800
9600
19200
38400
57600
115200
138200
172800
230400
345600
Data Bits
7
8
Parity
Even
Odd
None
Ignore
Honor DSR
On
Off
SMTP Setup menu
Use
Primary SMTP Gateway
Primary SMTP Gateway Port
Secondary SMTP Gateway
Secondary SMTP Gateway Port
SMTP Timeout
5–30
Reply Address
To
Specify the rate at which data can be received through the serial port.
Notes:
•
9600 is the factory default setting.
•
138200, 172800, 230400, and 345600 baud rates are only displayed in the
Standard Serial menu. These settings do not appear in the Serial Option 1,
Serial Option 2, or Serial Option 3 menus.
Specify the number of data bits sent in each transmission frame.
Note: 8 is the factory default setting.
Set the parity for serial input and output data frames.
Note: None is the factory default setting.
Determine whether the printer uses the DSR Signal.
Notes:
•
Off is the factory default setting.
•
DSR is a handshaking signal used by most serial cables. The serial port uses
DSR to distinguish data sent by the computer from data created by electrical
noise in the serial cable. The electrical noise can cause stray characters to
print. Set this to On to prevent stray characters from printing.
To
Specify SMTP server gateway and port information.
Note: 25 is the default SMTP gateway port.
Specify the amount of time in seconds before the server stops trying to
send an e‑mail.
Note: 30 seconds is the factory default setting.
Specify a reply address of up to 128 characters in the e-mail sent by the
printer.
140
Advertisement
Table of Contents
