Polaris 2007 Two Stroke Service Manual page 141

21. Place the engine mount washers and fasteners (8) onto the
engine mount studs. Torque to specification.
Engine Mount Fasteners: 28 ft.lb (37.9 N-m)
22. Install the right hand chassis brace (9).
8
= T
9
23. Apply Blue Loctite™ to the rear fasteners (10), install all
the rear torque stop fasteners and torque to specification.
10
Rear Torque Stop Fasteners: 28 ft.lb (37.9 N-m)
24. Adjust the rear torque stop so that you have a clearance of
.010"-.030" (.25-.75mm) from the face of the torque stop
to the surface of the engine.
Rear Torque Stop Clearance:
.010"-.030" (.25-.75mm)
NOTE: If a new torque stop is installed, install it so
that the nub is touching the engine. This nub is .030"
(.75mm) long.
25. Adjust the engine isolator limiter (11) so that the stop is
bottomed out on the brace (12). See "Engine Isolator
Limiter Setting" on page 3.22.
11
ENGINE
= T
= In. / mm.
12
Torque Stop touching base
5.37
5