Samsung OfficeServ 7200 Technical Manual page 85

ASSEMBLING YOUR KEYSET
• Place the keyset face down on a flat surface.
• Insert notched ends of the support bracket into the channels located in the
upper section of the bottom panel. Push towards the top of the keyset to lock
in.
• Plug the handset cord into the jack marked with the
• Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
• Plug the eight-conductor LAN cable, from the wall, into the jack marked LAN
on the back of the keyset. (Connect the ITP keyset to any port on the local net-
work).
• Plug the eight-conductor PC cable, from the PC, into the jack marked PC on
the back of the keyset.
• Plug the power connector, from the power adapter provided, into the power
jack on the back of the keyset.
IMPORTANT NOTE:
• Be careful not to connect the Network LAN cable into the PC connector of the
phone.
• To prevent damaging the keyset, only use the Power Adapter that came with
the 5021D keyset.
• This manual assumes that the ITP keysets are connected to a functioning local
IP network. The local IP network must be able to communicate with the MCP
and MGI card in the iDCS 100 Release 2, iDCS 500 Release 2, or in the
OfficeServ 7200 system over IP. This is assumed regardless of whether the IP
keyset is on a local or remote network.
8
symbol.
Home Page
ITP-5021D SETUP
INITIALIZING THE ITP-5021D
Initially the ITP-5021D IP keyset will need to be setup to operate within the users
network.The Setup Menu is also used to make changes to the keyset, in the event
that the system information should change. The option chosen via scroll key will
be highlighted.
The station numbers will be automatically set by the iDCS 100 Release 2, iDCS 500
Release 2, and the OfficeServ 7200 systems once the necessary information has
been entered into the IP keyset. Enter ID and password of the server, as described
below to register the phone.
See your system administrator for specific Network and Server addresses. The
addresses necessary to set up the ITP-5021D are:
• IP Address of Station
• Network Gateway Address of Station
• Subnet Mask
• IP Address of System's MCP
• User ID
To get to the Set-Up Menu, unplug the power from the ITP-5021D phone, press
and hold the MENU button while plugging in the power cord back into the
phone. Now release the MENU button.
>1.Infomation
2.Network
Other items not shown on screen:
3.Load & Upgrade
4.System
ITP-5021D
Table of Contents
5.Server
6.Exit
9