Sofa/Bed Conversion - Winnebago Itasca Ellipse Owner's Manual

SECTION 9 –
FURNITURE AND SOFTGOODS
• The dinette table may be adjusted to the
position that best suits your needs by moving
the table slide mechanism forward or back.
NOTE: When the vehicle is in motion, the travel
latch must be in the locked position.
• Line up the latch mechanism with the table
bracket hole and push upwards to engage.
• Rotate the latch mechanism handle flat
against the table support to ensure that the
latch is secure.
9-4

SOFA/BED CONVERSION

Sofa to Bed
Lift the front edge of the sofa seat upward and
pull outward from the wall while gently pushing
downward on the backrest until the cushions lie
flat. The bed is now ready for use.
Bed to Sofa
Push the front edge of the seat toward the wall
while lifting upward on the backrest until the sofa
is fully seated against the wall.
SOFA/BED CONVERSION
(with Removable Armrests)
–If Equipped
Couch to Bed
1. Remove the armrests from both ends of the
couch by lifting upward. A "fin" on the
underside of the armrest holds it in place
between the cushion and side of the couch.
• Remove armrest by pulling upward
2. Lift the front edge of the sofa seat upward and
pull outward from the wall while gently
pushing downward on the backrest until the
cushions lie flat. The bed is now ready for use.
Bed to Couch
1. Push the front edge of the seat toward the wall
while lifting upward on the backrest until the
sofa is fully seated against the wall.
2. Slide armests into place at each end of the
sofa.