Winnebago Itasca Ellipse Owner's Manual page 96

SECTION 6 –
ELECTRICAL
• Do not open windows or vents on the end or
side of the vehicle where exhaust pipe of the
generator is located.
• Park the vehicle so that the wind will carry the
exhaust away from the vehicle. Also, note the
position of other vehicles to be sure their
exhaust will not enter your vehicle.
• Do not operate the generator engine while
parked if vegetation, snow, buildings,
vehicles, or any other object can deflect the
exhaust under or into the vehicle.
Check auxiliary generator oil level frequently
during periods of use. Refer to the generator
manufacturer's user guide provided in your
InfoCase for specific recommendations.
Replacing the Generator Air Filter
(42AD models only)
NOTE: It is recommended that the engine air
filter be changed every 500 hours of
running time. Replace it more often in
dusty environments.
Accessing the Air Filter
1. Open the front hood.
2. Remove all fasteners on the front and rear top
access panels (except for the last two fasteners
on the rear panel) with a 10 and 13 mm socket.
6-8
Do not remove the last two
fasteners (one located on
each side of the generator)
3. Remove side access panel (located on the
right side of the generator) by releasing the
latch (as shown in the following photo).
NOTE: Once the latch has been released, you
must close the latch again to allow the
side access panel to be removed
completely.
4. Lift up rear access panel (to allow for
clearance), then lift front access panel while
pushing back gently and remove.