Electronic Thermostat - Winnebago Itasca Ellipse Owner's Manual

SECTION 4 –
APPLIANCES AND SYSTEMS

ELECTRONIC THERMOSTAT

(Central Heat/Air Conditioning System)
The thermostat, located on the OnePlace
panel, controls heating, air conditioning, cooling
fan and heat pump operation.
Temperature Selector
Thermostat (Source) Switch
COOL= Air Conditioning
ELEC = Heat Pump
GAS = Furnace
Central Air Thermostat
NOTE: The thermostat does not automatically
switch between heating and cooling. You
must place the thermostat switch in the
desired position.
Heating
• Slide the thermostat switch to "Gas Heat"
position.
NOTE: Follow proper furnace lighting
procedures described previously in this
section.
• Adjust the temperature setpoint to personal
preference if needed. See "Changing
Temperature Setpoints."
Digital Thermostat Display
The digital display normally shows current
room temperature, with the word "ROOM" in
small letters at the left side of the display. When
you press the temperature selector button up or
down, the display will show the word "SET" and
the new temperature setpoint until you release the
button.
4-14
Changing Temperature Setpoints
To set the temperature to a new temperature,
simply press the Temperature Selector button up
or down until the temperature you want appears
®
in the display. The word "SET" will also appear
at the left side of the display while you are
changing the temperature setpoint. A few
seconds after you release the temperature selector
button, the display will return to showing the
current room temperature.
Cooling (A/C)
• Slide the thermostat switch to Cool position.
• Slide the Fan Mode and Fan Speed Switches
to the desired positions.
On/Low: A/C compressor cycles on and off
with the thermostat while fan runs
continuously at low speed.
On/High: A/C compressor cycles on and off
with the thermostat while fan runs
continuously at high speed.
Auto/Low: Fan runs at low speed and cycles
on and off with the A/C compressor as
controlled by the thermostat.
Auto/High: Fan runs at high speed and
cycles on and off with the A/C compressor as
controlled by the thermostat.
• Adjust the temperature setpoint to personal
preference if needed. See "Changing
Temperature Setpoints".
To Run Fan Only (No Heat or Air)
• Set Thermostat switch to OFF.
• Slide Fan Mode switch to On.
• Place Fan Speed switch to Lo or Hi as desired
• The fan will run continuously at the selected
speed and is not controlled by thermostat
setting. The display will show current room
temperature.