Winnebago Itasca Ellipse Owner's Manual page 77

Access Panel
(Removed)
A/C
Filter
A/C Filter Access
*MODEL 40CD
(Located beneath rear lavatory cabinet)
-Typical View
Filter Size: 14" x 20" x 1"
Beneath Floor Panel in Wardrobe
-Models 40BD and 40WD
• Remove floor panel from wardrobe as shown
in the following photo to access filter.
AC/Furnace Filter Access
*MODELS 40BD and 40WD
(Located under wardrobe floor panel)
-Typical View
Filter Size: 14" x 20" x 1"
Filter must be installed with airflow markings
(arrows) pointing downward.
NOTE: Do not block the filter in any way, such
Inside Return Air Vents
-Model 42AD
Return Air Vents throughout the ceiling of the
coach and must be inspected monthly and
Lavatory
cleaned periodically so the air conditioners will
Cabinet
operate efficiently.
on the driver side of the coach. Return Air Vents
are located on the passenger side of the coach. It
is the Return Air Vents in which the cleanable air
filters are installed.
water to clean the air filters. When finished,
allow air filters to air dry.
NOTE: There are multiple Supply and Return
(Located throughout the ceiling of the coach)
• Unlatch clips located on the sides of the Return
• Remove air filter to clean.
APPLIANCES AND SYSTEMS
as by setting packages or newspapers,
etc. in front of the return air grate. There
must be free airflow for the air
conditioner to operate efficiently.
Air conditioner filters are located inside the
Supply airflow comes from the vents located
It is recommended to use mild soap and warm
Vents throughout the coach. Therefore,
you must remember to remove each
separate air filter from each Return Air
Vent to clean.
Return Air Vent
Supply
(Remove Return Vent
Air Vent
cover to access filter)
Supply/Return Air Vents
*MODEL 42AD
-Typical View
Air Vents and remove.
SECTION 4 –
4-23