Entry Step - Electric - Winnebago Itasca Ellipse Owner's Manual

SECTION 12 –
MISCELLANEOUS
Whenever there is a loss of AC power to the
fireplace, the remote control provided in your
InfoCase will need to be reprogrammed.
Fireplace Remote Control
Further Information
See the fireplace user guide provided in your
InfoCase for complete operating and
maintenance instructions.
ENTRY STEP – ELECTRIC
–If Equipped
WARNING
Do not use step unless fully extended.
Do NOT stand on step when vehicle
ignition switch is turned to either the "On"
or "Start" position.
The step will automatically retract, which
may cause personal injury.
The power switch for the electric entry step is
located to the left of the main entry door as you
enter the coach.
12-6
Entry Step Switch
(Located near the entrance door)
-Typical View
The step has several automatic extend/retract
functions that are controlled by the position of a
sensor mounted on the inner edge (hinge side) of
the screen door.
Automatic Mode - Entry Step
Switch ON
(Step Operates with Door)
With the Step switch in the ON position, the
step is in Automatic Mode. This means it will
extend and retract automatically whenever the
screen door is opened or closed.
Stationary Extended Mode - Step
Switch OFF
(Step Remains Extended)
With the Step power switch in the OFF
position, the step will extend when the screen
door is opened and will stay extended whether
the door is opened or closed.
NOTE: The step switch is "locked" in the OFF
position. You must press the red button to
unlock the switch.
This position is normally used to keep the step
extended when parked at a campsite or whenever
people will be going in and out the vehicle
frequently.
Automatic Retraction Feature
The step is equipped with an automatic
retraction feature that stores the step
automatically if the main entry door is closed and
the Ignition Switch key is turned to the On or Run
positions.