Ice Maker - Winnebago Itasca Ellipse Owner's Manual

SECTION 4 –
APPLIANCES AND SYSTEMS
• Press the MODE button to select energy
source. There are three settings:
LP (Gas Mode) - Refrigerator will operate on
gas from the propane tank if the main valve is
open and the tank contains gas.
AC (Electric Mode) - Refrigerator will
operate on 120-VAC household current if the
shoreline is connected or the auxiliary
generator is running.
AU (Automatic Mode) - Refrigerator will
automatically start operating on 120-VAC
household current if the shoreline is
connected or the auxiliary generator is
running. If electricity is lost, it will
automatically switch over to LP gas operation
if gas is available.
NOTE: To avoid discharging house batteries,
turn the Inverter OFF or switch the
refrigerator to GAS mode anytime you
are running the refrigerator with the
shoreline unplugged.
The refrigerator draws its electrical
current through the inverter and not
directly from the shoreline.
If the refrigerator is in ELECTRIC or
AUTO mode, it will continue to draw
power from house batteries through the
inverter when the shoreline is unplugged
unless the Inverter is turned OFF.
• Press the SET TEMP button to change
temperature setting from 1 to 9 on display.
Start at the coldest setting to ensure coldest
temperature in the freezer compartment, then
adjust warmer as necessary after cold* food
has been added.
*The refrigerator will retain temperature
more efficiently if food is already cold before
placing inside.
4-2
Basic Operation (Dometic
"Sidewise")
-If Equipped
• To start up the refrigerator, press the main
power ON/OFF button.
• Set clock when display panel shows
horizontal bars (- - -).
• To enter TIME MODE, keep SET key pressed until
figures flash on the display panel. Hours are to the
left and minutes are to the right.
• Press SET key to adjust to local time. AM or PM
should also be set here.
• Store each setting by pressing AUTO/STORE key or
use the automatic store function (wait 5 seconds).
• To set the thermostat range, press the SET
button to the desired setting (1 to 5, with 5
being the coldest.) Store by pressing the
AUTO/STORE button or use the automatic
store function (wait 5 seconds).
• To select energy mode of operation, press the
AUTO/STORE button to select Auto mode
operation or locked up to LP-Gas mode
operation only.
NOTE: Current mode of operation and energy
source (AC or GAS) is indicated by a dot
on the LED panel.
Further Information
For further information and operating
cautions, see the refrigerator operating
instructions included in your InfoCase.

ICE MAKER

–If Equipped
Some refrigerators are equipped with an
automatic ice maker system. The ice maker unit
is installed in the freezer compartment of the
refrigerator.
®