Winnebago Itasca Ellipse Owner's Manual page 140

SECTION 9 –
FURNITURE AND SOFTGOODS
3. The gap between the footrest and seat should
provide ample room to enter and exit the
lounge. If you wish, however, you can unlatch
the footrest and push it against the lounge seat.
NOTE: The footrest "drawer" will latch when
pulled out completely and must be
unlatched to push back in when stowing
the footrest.
Tip for "power users"
• If you have the footrest section unlatched and
positioned against the seat cushion, it will
move out with the lounge when you press the
recline switch.
• When you return to upright position, you can
hook your heels over the front edge of the
footrest section and pull it back with you.
• Then, when you want to get up, simply push
the footrest section forward with your feet to
provide a gap for you to exit.
9-6
Pull
Strap
To Convert to Bed
1. Extend footrest section and push together with
lounge seat cushion,
2. then press recline button until entire lounge
lies flat.
3. Reverse steps to return to lounge seating.
NOTICE
Do not recline the lounge completely flat
unless the footrest trundle section is
extended. Do not occupy the lounge
when elevating the seat back from the flat
bed position to upright lounge position. If
house battery voltage is low, the
mechanism may require assistance by
lifting the seat back while returning
upright from flat bed position.
WARNING
Keep people away from operating
mechanism and pinch hazard areas
during use. Failure to do so could cause
injury.