Marker Light Courtesy Flash; Cruise Control Functions - Winnebago Itasca Ellipse Owner's Manual

• Press and release to blink or flash the
headlights.
• Night: If the headlights are already turned on,
pressing the switch will blink them off briefly.
• Day: If the headlights are off, pressing the
switch will flash them on briefly.
NOTE: Truckers often use this signal to indicate
to a passing rig when it is clear to pull
back into the lane ahead of them.

Marker Light Courtesy Flash

• Press and release to blink or flash the marker
(clearance) lights.
• Night: If the marker lights are already turned
on, pressing the switch will blink them off
briefly.
• Day: If the marker lights are off, pressing the
switch will flash them on briefly.
NOTE: Truckers often use this signal as a
greeting or an expression of thanks for
assistance in passing, etc.

Cruise Control Functions

On/Off (Cruise System On/Off)
• Press to turn cruise control system on or off.
• This will also erase previously set speed.
DRIVING YOUR MOTOR HOME
Set (Set Speed/Coast)
• Press to maintain current desired driving
speed. Will not work below 40 mph.
• This button will also perform "Coast" feature.
Press and hold until vehicle slows to desired
speed and release to establish new "set"
speed.
Res (Resume/Accel)
• Press to return to previous "set" speed after
braking or reducing speed.
Cancel
• Press to switch cruise function off without
losing current "set" speed.
WARNING
Do not operate the cruise control on icy or
extremely wet roads, winding roads, in
heavy traffic, or in any other traffic
situation where a constant speed cannot
be maintained.
Wiper Functions
There are four wiper control buttons:
• Wiper On - HI/LO
• Wiper Off
• Wiper Delay
• Wash/Wipe
SECTION 3 –
3-15