Connecting The Terminal Power Pack - VeriFone VX 520 Installation Manual

Connecting the
Terminal Power
Pack
CAUTION
NOTE
To connect the
terminal power pack
WARNING
When you have finished connecting optional peripheral(s), you are ready to
connect the VX 520 terminal to the provided power source.
Using an incorrectly rated power supply may damage the terminal or cause it not
to work as specified. Before troubleshooting, ensure that the power supply being
used to power the terminal matches the requirements specified on the bottom of
the terminal. (See Chapter
specifications.) Obtain the appropriately rated power supply before continuing
with troubleshooting.
Plugging in the power pack to a power source automatically turns on the terminal.
1
Remove the terminal rear cover to access the power port.
2
Insert the round barrel connector (see
Figure 16 VX 520 Power Pack Connection
3
Rotate the power plug counter-clockwise and flush against the side panel to
lock the plug in place.
4
Route the cable in the direction of the arrow above the power port and sling
the cable over the underside of the thermal paper container.
5
Close the terminal rear cover.
6
Insert the AC power cord into the power pack.
7
Plug the AC power cord into a wall outlet or powered surge protector.
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
Disconnecting the power during a transaction may cause transaction data files
not yet stored in terminal memory to be lost.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
3, Specifications, for detailed power supply
Figure 16) into the power port.
T
ERMINAL
VX 520 Setup
VX 520 I G
NSTALLATION UIDE
S
ETUP
29