VeriFone VX 520 Installation Manual page 41

5
6
Before inserting the MSAM card, position it as shown in
NOTE
gold contacts facing down. The cardholder connector base has an image
resembling the notched corner of an MSAM card to ensure the card is positioned
correctly.
7
Connecting The VX 520 Sprocket terminal supports some peripheral devices designed for use
Optional Devices
with electronic point-of-sale terminals.
Before connecting any peripheral device, remove the power cord from the
CAUTION
terminal. Reconnect the power cord only after you are finished connecting the
peripheral device(s). For complete information about peripheral installation and
use, refer to the user documentation supplied with those devices.
NOTE When the VX 520 Sprocket terminal is powered via the corded power supply, the
terminal provides 1.7 A at 24V DC. This power will drive most VeriFone
accessories. Contact your local VeriFone representative for more information.
Different terminals support different devices, so for more information about
optional devices, please contact your VeriFone distributor.
Optional Device Connections
The VX 520 Sprocket terminal has a port that can operate either as a PIN pad port
or an RS-232 port, depending on the power source available.
Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
Install an MSAM card by carefully sliding it into the slot until it is fully inserted.
Return and secure the MSAM cardholder cover with the screw.
T
ERMINAL
VX 520 Sprocket Setup
Figure 26, with the card's
VX 520 I G
NSTALLATION UIDE
S
ETUP
41