Installing Your Machine
User Parameters
Setting the User (Internet) Parameters
See Operating Instructions (For Facsimile) if you wish to set the basic settings (User Parameters).
Before starting, you will need a completed copy of page 15 (Pre Installation Information). For your machine
to be able to operate on the Network properly, the following five (5) Basic Parameters must be pre-
programmed into the machine.
• IP Address
• Subnet Mask
• SMTP Server Name or IP Address
• Default Router IP Address
• Email Address
Make sure that the FAX/EMAIL lamp is ON. If not, press
1
2
.
3
repeatedly until display shows;
4
Enter the IP Address using the keypad. Press
enter the period ".". (See Note 4)
Ex:
1 2 3
5
To continue setting other parameters, or press
to return to standby.
NOTE
1. To scroll the display to desired User Parameter in Step 3, press
2. The above IP Address fields require an entry to continue. If you wish to erase any of the above
IP Addresses (leave it Blank) and continue to the next Step, press
"0.0.0.0" and press
press
3. If the DNS Server is not available, change the setting of the Fax Parameter No. 161 (DNS
Server) to "Invalid", then enter the IP Address instead.
4. For convenience, you can use
Otherwise
1 7 8
2 4 0
. Other IP Addresses do not require an entry to continue, just
SET
and press
CLEAR
SET
is used to enter an asterisk in other condition.
to select the "FAX/EMAIL" mode.
SET MODE
ENTER NO. OR
1:USER PARAMETERS?
PRESS SET TO SELECT
IP ADDRESS
❚
to
IP ADDRESS
123.178.240.3❚
3
SUBNET MASK
❚
STOP
to proceed.
to enter a period "." while programming IP Addresses only.
(1-4)
∨ ∧
or
.
, then enter
CLEAR
25