Setting Up Your Machine For Relayed Transmission - Panasonic DP-1810F Operating Instructions Manual

Setting Up Your Machine for Relayed Transmission

Programming the End Receiving Station into your Auto Dialler
If the Fax Parameter No. 140 (LAN RELAY XMT REQUEST) is set to "Valid", you can enter the Relay
Address (ABBR No.) by the following procedure.
To set a One-Touch/ABBR for Relayed Transmission Request
Make sure that the FAX/EMAIL lamp is ON. If not, press
1
2
.
Ex:
3
Press a One-Touch key (01-52).
Ex:
01
4
To change the input mode (between "ENTER EMAIL
ADDRESS" and "ENTER TEL. NO."),
press
5
Enter the telephone number (up to 36 digits).
If the Relay and the End Receiving Stations are both in
the same area, omit the Country Code and the Area Code
from the End Receiving Station. The End Receiving
Station is a local telephone number as viewed from the
Relay Station.
6
7
Enter the station name (up to 15 characters) by using the
keypad. (See page 44)
Ex:
R O M E
8
Continued on the next page...
.
Relayed Transmission
to select the "FAX/EMAIL" mode.
1:ONE-TOUCH
2:ABBR NO.
ONE-TOUCH<
PRESS ONE-TOUCH
<01>
ENTER EMAIL ADDRESS
<01>
ENTER TEL. NO.
<01>
3961111234❚
<01>ENTER NAME
3961111234
<01> ROME❚
3961111234
<01> RELAY ADDRESS
>
❚❚❚
103