Inbound Routing; Setting The Routing Parameters - Panasonic DP-1810F Operating Instructions Manual

Inbound Routing

Setting the Routing Parameters

Your machine can route documents received from a G3 fax machine to email address(s) or to Internet Fax
machine(s) connected to a LAN as an email, as well as to other G3 fax machine(s) over the telephone line.
To use this feature, the Fax Parameter No. 152 "SUB-ADDRESS ROUTING" and/or No. 153 "TSI
ROUTING" must be set to "2:Valid".
No. 152 SUB-ADDRESS ROUTING: Set this parameter to perform an ITU-T sub-address query within its
auto dialler and to route the received document(s) to the corresponding stations email address(s) or
telephone number(s).
No. 153 TSI ROUTING: Set this parameter to perform a Numeric ID (TSI frame information) query within its
auto dialler and to route the received document(s) to the corresponding stations email address(s) or
telephone number(s).
No. 154 ROUTING HEADER FORMAT: Use this parameter to select the type of email header to be included
in the "From" field of each routed faxes. (Default setting is "1:Originator")
Originator : The originating fax machine's TSI will appear in the "From" field of the routed email.
Relay Station : The routing station's email address will appear in the "From" field of the routed email.
No. 155 PRINT ROUTED DOCUMENT : Set this parameter to select whether a received fax to be routed is
always printed on your machine or only when the routing operation fails.
To set the above Inbound Routing parameters, follow the Steps below.
Make sure that the FAX/EMAIL lamp is ON. If not, press
1
2
3
.
4
for "INVALID"
1
or
for "VALID"
2
5
Continued on the next page...
to select the "FAX/EMAIL" mode.
SET MODE (1-4)
∨ ∧
ENTER NO. OR
FAX PARAMETER(1-164)
NO.=❚
152 SUB-ADDR ROUTING
1:INVALID
152 SUB-ADDR ROUTING
1:INVALID
152 SUB-ADDR ROUTING
2:VALID
153 TSI ROUTING
1:INVALID
91