Access List; Access List Setting - EverFocus EDN Series User Manual

7.7 Access List

7.7.1 Access List Setting

Use this page to specify IP addresses that are allowed / denied to access this camera. By default, any
IP address can access the camera.
Note:
1. The user can only use either the Allow or Deny filter type because the allow and deny functions
cannot work simultaneously.
2. Switching the configured filter type will erase all the previously added filter list, so please
carefully decide which filter type you want to use before applying the
Current Access List is: Check Enable to display and configure the following settings.
Filter Type: Select Allow to allow the IP address configured below to access the camera. Select Deny
to deny the IP addresses configured below from accessing the camera.
Access List Setting: Select Add address to add allowed or denied addresses. Select Delete address to
delete the added allowed or denied addresses.
Rule: Select a network rule and then fill in the IP information in the below boxes.
- Single: Type a single IP address in the IP Address field below.
- Network: Type the IP address and subnet mask in the field below.
- Range: Type a range for the IP addresses.
Click Apply to apply the changes or Cancel to cancel the changes and return to the previous settings.
56
EDN2160/2260/2560
setting.