Page 2
EDN Plus Series 1. Overview The EDN Plus series IP dome is designed for indoor use. The series comes in three models: EDN3160 Plus / 3260 Plus / 3340 Plus. Model Name Megapixel P-Iris EDN3160 Plus 1.3 MP EDN3260 Plus...
Note: Contact the shipper if any items appear to have been damaged in the shipping process. If any items are missing, notify your EverFocus Electronics Corp. Sales Representative or Customer Service Branch. Please also keep the shipping carton for possible future use.
EDN Plus Series 3. Installation There are two ways to mount the EDN Plus IP Dome: Wall-Surface Mount and In-Ceiling Mount. Wall-Surface Mount: 1. Paste the supplied mounting template onto a desired location on the wall. Drill the four red cross marks, and the red circle mark only if you wish to run the wires into the wall.
Page 5
EDN Plus Series 4. Unscrew the three screws and take out the camera body. 5. Thread the cables on the side of the camera case. If you want to wire the cables through the wall, run the cables through the hole at the bottom.
Page 6
EDN Plus Series 8. Place and screw the camera body back to the camera case. 9. Connect the network, power and other cables to the camera. Refer to 2. 5-Pin Data Cable. 10. Optionally insert a micro SD / SDHC card to the card slot. See No.5 in 1. Overview.
Page 7
EDN Plus Series Rotational Adjustment: Using the rotate screw. 180° Tilt Adjustment: Using the two tilt screws. 64° 13. Secure the cover back to the camera. In-Ceiling Mount: 1. Paste the supplied mounting template onto a desired location on the wall. Cut a circle on the ceiling along the circle edge of the mounting template.
Page 8
EDN Plus Series 4. On the back side, make sure the black plastic clips are slightly above the ceiling board and pointing outward. 5. Tighten the bracket screws from the front side of the camera. 6. Connect the network, power and other cables to the camera. Refer to 2. 5-Pin Data Cable.
EDN Plus Series 4. Accessing the Camera You have to assign an IP address for your camera to be accessible. To assign an IP address to the camera, use the IP Utility (IPU) software included in the software CD. Please connect the camera in the same LAN of your computer.
Page 10
EDN Plus Series 5. To change the IP address, double-click the IP Address of the camera. Type a new IP address and then click Set IP Address to save the settings. You can also change the other settings by double-clicking the values. After configuring the values, click Save Configuration.
EDN Plus Series 5. Network Connections You can use one of the methods below to connect the camera to the network. Router or LAN Connection This is the most common connection in which the IP camera is connected to a router and allows multiple users on and off site to see the IP camera on a LAN/WAN (Internet).
EDN Plus Series Direct High-Speed Connection In a Direct High-Speed Connection, the camera connects directly to a modem without the need for a router. You need to set the static or dynamic WAN IP address assigned by your ISP (Internet Service Provider) in the camera’s configuration web pages.
EDN Plus Series 6. Upgrading Firmware You can upgrade camera’s firmware using the IP Utility software, which is included in the software 1. Follow Step 1 to Step 4 in 5. Assigning an IP Address to log in the camera.
Page 14
FAX: +86 755 2765 0337 www.everfocus.com.cn www.everfocus.com.cn marketing@everfocus.com.cn marketing@everfocus.com.cn EverFocus USA - New York: EverFocus USA - California: 1801 Highland Avenue, Unit A, Duarte, CA 91010, USA 415 Oser Avenue, Unit S, Hauppauge, NY 11788, USA TEL: +1 626 844 8888...