Epson Stylus Pro 3800 Service Manual page 183

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
29. Connect the cables to the CN63, CN69, CN70, CN71 and CN72 on the BOARD
ASSY., MAIN.
30. Push the BASE, ENCLOSURE back into the original position.
31. Route and fold back the FFCs on the COVER, ENCLOSURE, ASSY taking care
of the followings.
Keep 5 mm or more away from the U-shaped cutout
Avoid covering the hole shown in
32. Install the BASE, ENCLOSURE.
33. Install the INK, SYSTEM, ASSY..
When installing the COVER, CR, make sure that the cables of the
APG SENSOR is routed through the cutout of the sponge of the
COVER, CR.
Cable of APG SENSOR
34. Install the COVER, CR. (p152)
35. Install the HOUSING, UPPER. (p107)
DISASSEMBLY & ASSEMBLY
Figure 4-125
(p111)
(p153)
COVER, CR
Sponge
Disassembly/Assembly Procedure (Group 1)
CN63
Figure 4-124. Connecting the Cables
5 mm
U-shaped cutout
Figure 4-125. Routing the FFCs on the COVER, ENCLOSURE, ASSY
Revision C
CN69
CN70
CN71
CN72
BASE, ENCLOSURE
Holes
COVER, ENCLOSURE, ASSY
183