Epson Stylus Pro 3800 Service Manual page 145

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
6. Release the rear end of the TORSION SPRING, 0.15 from the cutout of the main
frame in the direction of the arrow, and remove the TORSION SPRING, 0.15 from
the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT.
7. Remove the two screws that secure the GUIDE, PAPER GUIDE, BOARD
PAPER, RIGHT.
Two C.B.P. 3 x 6 screws (9 ± 1 kgf.cm)
When removing/installing the C.B.P. 3x6 screws that secure the
C H E C K
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT, use a stubby
P O I N T
screw driver or put a screwdriver (with a 110 mm or longer shaft is
recommended) through the holes on the FRAME, ASSY., SUB,
RIGHT as shown in Figure
DISASSEMBLY & ASSEMBLY
4-69.
Disassembly/Assembly Procedure (Group 1)
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT
C.B.P. 3x6
TORSION SPRING, 0.15
Figure 4-69. Removing the TORSION SPRING, 0.15 and the screw from the GUIDE,
PAPER GUIDE, BOARD PAPER, RIGHT
Revision C
Put the screwdriver
through this hole.
145