Epson Stylus Pro 3800 Service Manual page 144

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.8.3 FRAME, PAPER, EJECT, ASSY
1. Remove the HOUSING, UPPER.
2. Remove the STACKER, ASSY.
3. Remove the BOARD PAPER TRAY.
4. Unlock the CARRIAGE, ASSY. and move it to the center.
5. Remove the screw that secures the SLIDER, FRAME, EJ, RIGHT and remove it.
One C.B.S. 3 x 6 screw (9 ± 1 kgf.cm)
When removing the C.B.S. 3x6 screw that secures the SLIDER,
C H E C K
P O I N T FRAME, EJ, RIGHT, use a stubby screw driver or put a
screwdriver (with a 110 mm or longer shaft is recommended)
through the holes on the FRAME, ASSY., SUB, RIGHT as shown
in Figure 4-68.
Insert the two guide pins of the SLIDER, FRAME, EJ, RIGHT into
the positioning holes of the main frame to secure the SLIDER,
FRAME, EJ, RIGHT.
positioning holes
DISASSEMBLY & ASSEMBLY
(p107)
(p134)
(p140)
(p92)
guide pins
Disassembly/Assembly Procedure (Group 1)
Right Side
C.B.S. 3x6
Put the screwdriver
through this hole.
Figure 4-68. Removing the SLIDER, FRAME, EJ, RIGHT
Revision C
SLIDER, FRAME, EJ, RIGHT
144