Epson Stylus Pro 3800 Service Manual page 153

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
4.3.9.3 INK, SYSTEM, ASSY.
Since the INK, SYSTEM, ASSY. of Epson Stylus Pro 3800/3800C/
C A U T I O N
3850 and Epson Stylus Pro 3880/3885/3890 has no compatibility, be
careful not to install the wrong one.
1. Remove the HOUSING, UPPER.
2. Remove the three screws that secure the SHIELD PLATE, HOLDER, ASSY.
Three C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
3. Slide the SHIELD PLATE, HOLDER, ASSY. toward the rear to remove the two
tabs on the rear side, and remove the SHIELD PLATE, HOLDER, ASSY.
Insert the two positioning holes of the SHIELD PLATE, HOLDER,
ASSY. over the guide pins of the FRAME, HOLDER, IC, ASSY., to
secure the SHIELD PLATE, HOLDER, ASSY.
FRAME, HOLDER, IC, ASSY.
DISASSEMBLY & ASSEMBLY
(p107)
positioning points
Disassembly/Assembly Procedure (Group 1)
SHIELD PLATE, HOLDER, ASSY.
tabs
C.B.S. 3x6
Figure 4-80. Removing the SHIELD PLATE, HOLDER, ASSY.
Revision C
153