Epson Stylus Pro 3800 Service Manual page 180

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890
Before carrying out the following procedure, perform check 1 to 3
C A U T I O N
below. When one of them is not satisfied, go back to
reassemble the CABLE ASSY., ASP again.
Check 1
The gap between the Frame R and GUIDE, TUBE, CR is 2 mm
or more.
Check 2
Insert a sheet of copy paper (30 mm x 150 mm) between the ink
tube and FFC, and move it from side to side between the clamp
and carriage. The paper moves smoothly without getting stuck.
Clamp
DISASSEMBLY & ASSEMBLY
Step12
to
2 mm or more
Frame R
GUIDE, TUBE, CR
Copy paper
30 mm
Disassembly/Assembly Procedure (Group 1)
Check 3
C A U T I O N
The gap between the guide plate and ink tube is 5 mm or less.
Revision C
Ink tube
5 mm or less
180