Draytek Vigor IPPBX 2820 Series User Manual page 91

frequency of the ring tone. It is recommended for you to use
the default setting.
Call Waiting Tone Power Level - This setting is used to
adjust the loudness of the call waiting tone. The smaller the
number is, the louder the tone is. It is recommended for you
to use the default setting.
DTMF DTMF Mode – There are four DTMF modes for you to
choose.
InBand - Choose this one then the Vigor will send the
DTMF tone as audio directly when you press the keypad on
the phone
OutBand - Choose this one then the Vigor will capture the
keypad number you pressed and transform it to digital form
then send to the other side; the receiver will generate the
tone according to the digital form it receive. This function is
very useful when the network traffic congestion occurs and
it still can remain the accuracy of DTMF tone.
SIP INFO- Choose this one then the Vigor will capture the
DTMF tone and transfer it into SIP form. Then it will be
sent to the remote end with SIP message.
Payload Type (rfc2833) - Choose a number from 96 to
127, the default value was 101. This setting is available for
the OutBand (RFC2833) mode.
After finishing all the settings here, please click OK to save the configuration.
VigorIPPBX 2820 Series User's Guide 83