Draytek Vigor IPPBX 2820 Series User Manual page 219

DSL Modem Settings
ISP Access Setup
IP Address from ISP
Obtain an IP address
automatically
Specify an IP address
DNS Server IP
Address
VigorIPPBX 2820 Series User's Guide
this function will be closed and all the settings that you
adjusted in this page will be invalid.
Set up the DSL parameters required by your ISP. These are
vital for building DSL connection to your ISP.
VPI - Type in the value provided by ISP.
VCI - Type in the value provided by ISP.
QoS Type -Select a proper QoS type for the channel.
Protocol - Select a proper protocol for this channel. There are
three options, PPPoE, PPPoA and MPoA for you to select. The
following settings will be changed according to the protocol
selected here.
Encapsulating Type - Drop down the list to choose the type
provided by ISP.
Enter your allocated username, password and authentication
parameters according to the information provided by your ISP.
If you want to connect to Internet all the time, you can check
Always On.
Username – Type in the username provided by ISP in this
field.
Password – Type in the password provided by ISP in this
field.
PPP Authentication – Select PAP only or PAP or CHAP for
PPP.
Idle Timeout – Set the timeout for breaking down the Internet
after passing through the time without any action. This setting
is active only when the Always On option is note selected.
Fixed IP - Click Yes to use this function and type in a fixed IP
address in the box of Fixed IP Address.
Fixed IP Address -Type a fixed IP address.
Click this button to obtain the IP address automatically.
Router Name – Type in the router name provided by ISP.
Domain Name – Type in the domain name that you have
assigned.
Click this radio button to specify some data.
IP Address – Type in the private IP address.
Subnet Mask – Type in the subnet mask.
Gateway IP Address – Type in gateway IP address.
Type in the primary IP address for the router. If necessary, type
in secondary IP address for necessity in the future.
211