Front Door Installation - Regency ULTIMATE U39 Owners & Installation Manual

INSTALLATION
7) Place the Left Top Log D)02-46 on the pin
on Log B)02-56 and on top of the cutout
on Log A)02-65.
D)02-46
B)02-56
C)02-44
Pin
8) Place Front Right Log E)02-45 on the two
pins as shown.
E)02-45
9) Place the lava rock in the area between
the left and right logs, leaving a space in
the middle for log (F) 02-47.
10) Place the notch in Center Log F)02-47 over
Log E)02-45 and across the cutout on Log
A)02-65.
F)02-47
Notch Cutout
28
11) Position notch in Front Right Log G)02-48
on Log F)02-47 and push the bottom right
edge against the bracket on the burner
tray.
A)02-65
A)02-65
Notch
Cutout
E)02-45
Side View
The bottom right edge of Log G)02-48 must
sit snugly against the bracket
12) Test fi re to ensure proper light off (make
sure fl ame fl ows smoothly from one end
of burner to the other. If there is any fl ame
hesitation, check that area for any blockage
of the burner port.
B)02-56
C)02-44
A)02-65
E)02-45
1) Open the two side panels.
G)02-48
2) Slide the door onto the two hinge pins making
3) Close the door. The
E)02-45
G)02-48
4) The latches should
Bracket
5) Remove the blue plastic protective coating
A)02-65
6) Test the seal around the door by placing
E)02-45
Note:
Regency ® U39 ULTIMATE Direct Vent Freestanding Gas Stove
FRONT DOOR
INSTALLATION
(packaged separately)
sure the two pieces are fl ush together. See
diagram 1.
latch plate must be
centered around the
alignment pin. See
diagram 2. If the latch
plate interferes with the
corner of the stove you
may want to angle the
plate slightly so the
door closes easier.
already be at the proper
setting. If they are
too hard or too easy
to close, you may want to adjust them by
loosening the latch catch. See diagram 3.
Diagram 2
from the glass.
a piece of paper between the unit and the
door, close the door and try to pull the paper
out. If it slips out easily, then the door is not
properly sealed. Tighten or loosen the latch.
See diagram 3.
Diagram 3
The door latch may require
adjustment as the door gasket
material compresses after a few fi res
and after glass replacement. Turn
the latch catch inward or outward
to loosen or tighten.
Diagram 1