Table of Contents
Advertisement
FRONT DOOR
INSTALLATION
(packaged separately)
1. Open the two side panels.
2. Slide the door onto the two hinge pins making
sure the two pieces are flush together. See
Diagram 1.
Diagram 1
3. Close the door. The latch plate must be
centered around the alignment pin. See
Diagram 2. If the latch plate interferes with
the corner of the stove you may want to angle
the plate slightly so the door closes easier.
Diagram 2
4. The latches should already be at the proper
setting. If they are too hard or too easy
to close, you may want to adjust them by
loosening the latch catch. See Diagram 3.
Diagram 3
FG39-2 Freestanding Gas Stove
5. Remove the blue plastic protective coating
from the glass.
6. Test the seal around the door by placing
a piece of paper between the unit and the
door, close the door and try to pull the paper
out. If it slips out easily, then the door is not
properly sealed. Tighten or loosen the latch.
See Diagram 3.
Note:
The door latch may require adjust-
ment as the door gasket material
compresses after a few fires and
after glass replacement. Turn the
latch catch inward or outward to
loosen or tighten.
OPTIONAL
REMOTE CONTROL
Use the Regency Remote Control Kit (Part #
910-086) approved for this unit. Use of other
systems may void your warranty.
The remote control kit comes with a hand held
transmitter and a wall mounting plate.
1. Choose a convenient location to mount
the hand held transmitter, protection from
extreme heat is very important.
The remote can also be used as a wall thermostat.
installation
FINAL CHECK
Before leaving this unit with the customer, the
installer must ensure that the appliance is firing
correctly. This includes:
1. Clocking the appliance to ensure the correct
firing rate (rate noted on label) at 15 minutes.
2. If required, adjusting the primary air to en-
sure that the flame does not carbon. First
allow the unit to burn for 15 min. to stabilize.
3. Check for proper draft.
CAUTION
Any alteration to the product that caus-
es sooting or carboning that results in
damage to the exterior facia is not the
responsibility of the manufacturer.
27
Advertisement
Table of Contents
