Optional Wall Thermostat; Optional Remote Control - Regency ULTIMATE U39 Owners & Installation Manual

INSTALLATION
PROPANE
For
*For installation of the DC Spark Box refer to the LP Conversion instructions in this manual.
OPTIONAL WALL
THERMOSTAT
A wall thermostat may be installed if desired.
Connect the wires as per the wiring diagrams.
Note that the wires are connected to the "TH"
on the gas valve. Use table below to determine
the maximum wire length:
Note: Preferable if the thermostat is installed
on an interior wall.
Regency ® offers an optional programmable
thermostat but any 250-750 millivolt rated non-
anticipator type thermostat that is CSA, ULC or
UL approved may be used.
CAUTION
Do not connect the millivolt
wall thermostat wires
to the 120V wires.
30
Units and Units Equipped with DC Spark Boxes*
Thermostat Wire Table
Recommended Maximum Lead Length
(Two-Wire) When Using Wall
Thermostat (CP-2 System)
Wire Size Max. Length
14 GA.
16 GA.
18 GA.
20 GA.
22 GA.
Regency
OPTIONAL REMOTE
Use the Regency
for this unit. Use of other systems may void
your warranty.
50 Ft.
The remote control kit comes with a hand held
32 Ft.
transmitter, a receiver and a wall mounting
20 Ft. plate.
12 Ft.
1) Choose a convenient location on the wall
9 Ft.
to install the receiver and the receptacle
box (protection from extreme heat is very
important). Run wires from the fi replace to
that location, use Thermostat Wire Table.
2) Connect the wires as per the wiring diagram
above.
® U39 ULTIMATE Direct Vent Freestanding Gas Stove
CONTROL
®
Remote Control Kit approved