Lights
7 of 10
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/6...
Close engine hood and check to
make sure that gap between hood
and headlight assembly (A) is
correct. See specification below.
Open hood and tighten down
mounting screws.
Remainder of assembly is reverse
of removal.
Headlight to hood gap
Dimension A
Adjust headlight aim as described
-
earlier.
Headlight lens, removing and
installing
If necessary, remove headlight
-
washer spray nozzles. See
Wipers and
Washers.
Remove front turn signal assembly
-
as described later in this repair
group.
Use plastic prying tool to detach and
remove trim piece below headlight
assembly.
5.0 ± 1.0 mm
(0.2 0.± 04 in.)
611
2/25/2009 11:15 PM