Seat Belts
3 of 10
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/7...
Detach harness connection (B).
Remove tensioner mounting bolt
(C).
Check tensioner mounting bracket
(arrow) for damage or bending.
Replace if necessary.
CAUTION!
A bent tensioner mounting bracket
may make it impossible to adjust
seat height.
When reinstalling:
Replace wire ties to relieve tension
on the pyrotechnic belt tensioner
harness connector.
Make sure tensioner harness
connector mounting bracket
(arrow) is installed correctly.
Tightening torques
Front seat to floor
(M10 fastener)
Seat belt to seat
Tensioner
mounting bracket
to seat rail
Tensioner to
mounting bracket
Front seat belt
45 Nm (33 ft-lb)
48 Nm (35 ft-lb)
24 Nm (18 ft-lb)
48 Nm (35 ft-lb)
2/25/2009 11:20 PM