Side-Impact Crash Sensor, Removing And Installing - BMW 1999-2005 M3 Service Manual

Airbag System (SRS)
2 of 3
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/7...
CAUTION!
Prior to disconnecting the battery,
read the battery disconnection
cautions given at the front of this
manual on page viii.
- Remove center utility tray between
front seats. See
Trim.
Cut open carpet on top of center tunnel
to access MRS II module.
- Remove module mounting nuts
and lift up control module. Detach
electrical harness connector.
Installation is reverse of removal.
-
Be sure that MRS module ground
cable is attached to the module
mounting stud.
Side-impact crash sensor,
removing and installing
Make sure ignition key is OFF.
-
Remove front seat. See
-
Seats.
Remove plastic door sill trim by lifting
to release clips at one end, then sliding
off. Fold up carpet towards rear seat
floor. If necessary, remove floor level
heater duct.
513 Interior
520
2/25/2009 11:21 PM