Lights
1 of 6
http://ebahn.bentleypublishers.com/BMW/3/E46/Repair%20Manuals/6...
Turn Signals, Taillights
Front turn signal assembly,
removing and installing
The procedure below also includes
turn signal bulb replacement.
With engine hood open, use a
screwdriver to press turn signal
assembly retaining clip down to
disengage from retaining tab on
headlight assembly frame.
Screwdriver must reach into fender
hole a minimum of 3 in. to reach the
retaining tab.
Push turn signal forward. Light
-
slides straight out.
-
Detach electrical harness
connector.
Twist and remove bulb from rear
-
of turn signal assembly.
CAUTION!
Do not touch bulb with your bare
hands. If necessary wipe bulb using
a clean cloth dampened with rubbing
alcohol.
Note:
630-5
2/25/2009 11:15 PM