Panasonic WJ-ND200K Setup Instructions page 64

I Send to
Enter the mail addresses of the recipient of the alarm
mail and the warning report mail. Enter the mail
addresses of the recipients for "Address1" - "Address4".
Enter up to 255 alphanumeric characters including
hyphens (-), periods (.) and at mark (@).
Up to 4 destinations can be registered.
Check the desired mail type (warning/alarm) to be sent.
Settings relating to Panasonic Protocol [Panasonic Alarm Protocol]
Perform the settings to notify a PC of event/error occurrence.
Screenshot 1
Click the [Comm] button in the "Setup" panel and then
click the "Panasonic Alarm protocol" tab to display the
"Panasonic Alarm protocol" page.
64
I From Address
Enter the mail address of a sender. Entered mail
addresses will be displayed in the "From" (sender) line.
Enter up to 127 alphanumeric characters including
hyphens (-), periods (.), at mark (@) and underscores
(_).
Note:
The following alphanumeric characters and marks
can be entered.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1
2 3 4 5 6 7 8 9 ! " # $ % ' ( ) * + , - . /: ; < = > ? @ [ \ ]
^ _ ` { | } ~
Step 1
Perform the following setup items.
I Port Number (to PC)
Enter a port number to be used to transmit a Panasonic
alarm protocol to the PC.
I Retry
Set the retry number of the Panasonic alarm protocol
transmission to the PC in case that the PC failed to
receive the Panasonic alarm protocol.
I Destination Address
Enter the address of the recipient. Enter the IP address
or host name for "Address1" - "Address4".
Up to 4 destinations can be registered.
Enter up to 255 alphanumeric characters including
hyphens (-), periods (.) and underscores (_).
Step 2
Click the [SET] button after completing the settings.