Panasonic WJ-ND200K Setup Instructions page 56

I FTP Port Number
Specify the FTP port number to be used.
Note:
The following port numbers and the port numbers
used for the HTTP port and for the site alarm setting
are unavailable for the FTP port number.
20, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110, 123,
161, 162, 546, 547, 995, 10001, 10002, 10003,
10004, 10005, 10006, 10007
I Port Setup
Perform the settings for the following items for each
port.
[DHCP]
Select "ON" or "OFF" to determine whether or not to use
the DHCP server. Select "ON" to obtain an IP address,
a subnet mask and a gateway from the DHCP server.
Set to "OFF" when entering the addresses above manu-
ally.
ON: Uses the DHCP server.
OFF: Does not use the DHCP server.
Default: OFF
Important:
• A different subnet should be set for each port.
• When "ON" is selected for "DHCP" and the record-
ing rate setting for "SD MEMORY REC" is config-
ured, an error may occur in the process of the start-
up of the unit when a request to write onto the SD
memory card is made.
This will happen when response from the DHCP
server takes time. However, this error will be correct-
ed once an address is provided to the unit.
[IP Address]
When "OFF" is selected for "DHCP", enter an IP
address.
For this unit, enter 4 units from the decimal numbers (0-
255) according to the network configuration.
[Subnet Mask]
Enter a subnet mask according to the network configu-
ration when "OFF" is selected for "DHCP".
[Gateway]
Enter the IP address of the gateway according to the
network environment when "OFF" is selected for
"DHCP".
56
[Line Speed]
The following are available for "Line Speed".
AUTO: Line speed will be applied automatically.
10-HALF: 10 Mbps semi duplex
10-FULL: 10 Mbps full duplex
100-HALF: 100 Mbps semi duplex
100-FULL: 100 Mbps full duplex
Important:
The line speed settings should be the same between
the unit and the hub.
(Recommended line speed: 100Mbps-FULL)
For example, when 100Mbps-FULL and 100Mbps-
HALF are set for the recorder and the hub respec-
tively, display/recording/playback of images may not
be performed correctly.
Note:
When the setup menu is closed after changing the
line speed, the unit will automatically restart.
Important:
A different subnet should be set for each port.
I DNS Setup
Select "MANUAL" or "AUTO" to enable IP address
searching by the host name using the DNS. Select
"OFF" when not using the DNS.
Selecting "AUTO" is available only when "ON" is select-
ed for "DHCP" (using the DHCP server).
Selecting "MANUAL" is available regardless of the set-
ting for "DHCP" (with or without using the DHCP serv-
er).
When "MANUAL" is selected for the DNS, enter the
DNS server addresses in "Primary" and "Secondary".
Enter 4 units from the decimal numbers (0-254).
[Domain Name]
Enter the domain name of this unit. Enter up to 255
alphanumeric characters including hyphens (-) and peri-
ods (.).
Note:
The first character of the domain name should be an
alphabetical character.