Functions For Events [Event] - Panasonic WJ-ND200K Setup Instructions

Functions for events [Event]

Perform the settings for event actions of each event type (site alarm and terminal alarm). Refer to the provided oper-
ating instructions for further information about each event type.
Basic settings for event actions [Basic Setup]
Perform the settings relating to event actions such as the alarm output duration and the buzzer sound duration of
each camera channel at an event occurrence (site alarm and terminal alarm).
Screenshot 1
Click the [Event] button in the "Setup" panel and then
click "Basic Setup" tab. The "Basic Setup" page will be
displayed.
36
Step 1
Perform the settings for each item.
I Alarm Output
Select the alarm output duration.
The following are available for alarm output duration.
OFF: No alarm output is supplied.
2 s/5 s/10 s/20 s/30 s/1 min
EXT: The alarm output will continue until the [ALM] but-
ton is clicked.
REC: The alarm output will be supplied during the event
recording is being performed.
I Buzzer
Select "OFF", "EXT", "REC" or a buzzer sounding dura-
tion at an event occurrence. The following are available
for buzzer sound duration.
OFF: The buzzer will not sound.
2 s/5 s/10 s/20 s/30 s/1 min
EXT: The buzzer will continue until the [ALM] button is
clicked or the [BUZZER STOP] button on the front
panel is pressed.
REC: The buzzer will sound only during the event
recording is being performed.
Step 2
Click the [SET] button after completing the settings.