Panasonic WJ-ND200K Setup Instructions page 44

Set the time zone and assign programs [Time Table]
Create timetables for each day of the week, and assign a program to each timetable. Up to 6 recording programs
can be created for each day of the week.
Screenshot 1
Click the [Schedule] button in the "Setup" panel and
then click the "Time Table" tab. The "Time Table" page
will be displayed.
Screenshot 2
The timetable of the selected day of the week will be
displayed.
Screenshot 3
The "Time Table" page will be displayed again.
44
Step 1
Click the button of the desired day of the week.
Notes:
• During a signal is being supplied from the
ALARM/CONTROL connector on the rear panel (the
external recording mode changeover terminal (pin
no. 24)) of the unit, the unit will work with the
timetable "EXT".
• It is possible to display the "Program" window
( page 39) by clicking the program title displayed
at the bottom of the table.
Step 2
Perform the settings for each item.
Refer to the following for further information about the
settings for each item.
Step 3
Click the [SET] button after completing the settings, and
close the window by clicking the [×] button at the top
right of the window.
Step 4
The set timetables and programs will be applied.
Programs will be displayed with different colors.
Program 1: Yellow
Program 2: Green
Program 3: Pale purple
Program 4: Dark blue