Removing The Lcd Module (Hp Authorized Service Providers Only); Figure 2-9. Removing The Hinge Covers And Icon Window Cover - HP OmniBook 3000 Service Manual

Removing the LCD Module
(HP Authorized Service Providers Only)
Required Equipment
• Small Phillips screwdriver, preferably magnetized.
• Pointed knife or probe.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the floppy drive or other plug-in module (see page 2-3).
3. Open the display fully.
4. Slide off the two plastic hinge covers about 5 mm, then lift them off. Use your finger or a small tool
to push outward next to the hinge.
5. Pry out and pop up the right end of the icon window cover at the plug-in module slot, then pop off
the cover.
Icon Window Cover
F1391-60928

Figure 2-9. Removing the Hinge Covers and Icon Window Cover

6. Pry off the two screw covers by the display hinges (use a pointed knife or probe), then remove the
two screws.
HP OmniBook 3000
Hinge Cover
F1391-60935 (2)
Removal and Replacement 2-11