Removing a RAM Board
(User-Replaceable)
Description
RAM board, 16-MB
RAM board, 32-MB
RAM board, 64-MB
Caution
Handle the RAM module only by its edges and provide proper grounding. Otherwise, you may
damage the board due to electrostatic discharge.
Required Equipment
• Small Phillips screwdriver.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove the hard disk drive (see page 2-4).
3. Slide open the RAM cover about 3 mm, then lift off the cover.
4. Release the two metal latches at the sides of the RAM board, so the free edge of the board pops up.
5. Pull the board out of the connector.
HP OmniBook 3000
Table 2-4. RAM Board Replacement Part Numbers
Figure 2-5. Removing the RAM Cover
Part Number
Exchange
Part Number
F1363-60001
F1363-69001
F1364-60001
F1364-69001
F1365-60001
F1365-69001
RAM Cover
F1391-60936
Removal and Replacement
2-7