7. Starting at the left side of the display, use your fingers to gently pull the display bezel toward the
edge of the display case until the snaps release. As the snaps release, work your way up the left
side, across the top, and down the right side—until only the bottom edge is attached.
8. Now use your fingers to gently lift up the inner, lower edge of the bezel away from the LCD until
the lower snaps release.
9. Remove the four screws from the corners of the LCD module.
10. Lift out the LCD module and move it to the left until you can unplug the two-wire cable at the
inverter PCA.
11. Tip up the top of the LCD module and gently unplug the connector near the top of the LCD module.
You have to remove a piece of Kapton tape to do this.
2-12
Removal and Replacement
Figure 2-10. Removing the Display Bezel
HP OmniBook 3000