Replacing Small Parts (User-Replaceable); Figure 2-6. Removing A Ram Board; Table 2-5. Replacing Small Parts (User-Replaceable) - HP OmniBook 3000 Service Manual

Reassembly Notes
• Insert the RAM board into the connector at about a 30° angle until it is fully inserted. Then press
down at both sides until both latches snap closed.
• Place the RAM cover about 3 mm from its closed position, then slide it closed.
Replacing Small Parts
(User-Replaceable)
The following small parts are user-replaceable.
Part
BIOS Cover
Feet
Hinge Cover
Icon Window Cover
I/O Door
RAM Cover
2-8 Removal and Replacement

Figure 2-6. Removing a RAM Board

Table 2-5. Replacing Small Parts (User-Replaceable)

Part Number Replacement Procedure
F1391-60929 On the bottom of the unit, insert a small flat-blade screwdriver
into the slot at the edge of the BIOS cover and pry it off.
F1391-60931 Insert a small flat-blade screwdriver under the end of the foot
and pry it loose. To replace, firmly press the adhesive side of the
foot into the recess.
F1391-60935 With the display fully open, slide off the hinge cover about
5 mm, then lift it off. Use your finger or a small tool to push
outward next to the hinge.
To reinstall the cover, slide the open end of the cover onto the
hinge, then lift the closed end over the bump and slide it in.
F1391-60928 1. Remove the floppy drive or other plug-in module.
2. With the display fully open, slide off the hinge cover about
5 mm, then lift it off. Use your finger or a small tool to push
outward next to the hinge.
3. Pry out and pop up the right end of the icon window cover at
the plug-in module slot, then pop off the cover.
F1391-60922 Open the door and flex the center of the door until one of the
side tabs releases.
F1391-60936 Remove the hard drive (see page 2-4). Slide the RAM cover
about 3 mm toward the hard drive opening, then lift off the cover.
HP OmniBook 3000