Removing The Lcd Module (Hp Authorized Service Providers Only); Table 2-7. Display Component Compatibility - HP OmniBook 900 Service Manual

Removing the LCD Module
(HP Authorized Service Providers Only)
Exchange Information
When returning a bad LCD module to HP, describe the symptoms on a piece of paper and attach
it to the part—do not use tape.
LCD Type*
OmniBook Model
Bezel, display
Cable, LCD flex
Cable, power
Case, display
Latch, display
Hinge, cover
Hinge, display (pair)
LCD Module
Support, left hinge
Support, right hinge
* To identify the type of LCD module, see the marking printed on the LCD flex cable where it plugs into the
base—it may be on the top or bottom of the cable.
† Models called 900† in this manual have no marking in the serial number, whereas models called 900B
have 900 B after the serial number.
Required Equipment
Small Phillips screwdriver.
Small flat-blade screwdriver.
Pointed knife or probe.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. On the display bezel, remove the two upper bumpers and two lower screw covers (using a pointed
knife or probe), then remove the four screws.
3. Along the top of the display, pull the bezel upward, toward the edge of the case, until the snaps
release.
4. Starting at the top corners, repeat along the left and right sides, pulling outward to release the left
and right edges.
5. Lift the top of the bezel away from the case about 7 cm (3 inches). The snaps along the bottom of
the bezel should release.
6. On the edge of the LCD module, unplug the LCD power wires from the power cable.
2-10 Removal and Replacement

Table 2-7. Display Component Compatibility

12" IBM 12" Mitsubishi
900†/900B 900†/900B
F1711-60915
F1711-60918 F1769-60913
F1711-60919
F1711-60978 F1711-60971
F1711-60979
F1711-60938
F1711-69039 F1711-69072
F1711-60910
F1711-60911
13" LG
900B
F1770-60906
F1770-60923
F1770-60912
F1770-60907
F1770-60901
F1770-60902
F1770-60908
F1770-69021
F1770-60914
F1770-60915
13" Unipac
900B
F1770-60910
F1770-69020
HP OmniBook 900