Removing The Top Case And Touchpad (Hp Authorized Service Providers Only); Figure 2-14. Removing The Keyboard - HP OmniBook 3000 Service Manual

Keyboard flex cable
(part of the keyboard)
Reassembly Notes
• After connecting the keyboard flex cable, insert the front edge of the keyboard into the front slots,
then slide it back. Make sure it is underneath the four plastic tabs along the back edge.
• Slide the open end of the hinge cover onto the hinge, then lift the closed end over the bump and slide
it in.
Removing the Top Case and TouchPad
(HP Authorized Service Providers Only)
Required Equipment
• Small Phillips screwdriver, preferably magnetized.
Removal Procedure
1. Unplug the ac adapter, if present, and remove the battery.
2. Remove these additional assemblies:
• Floppy drive or other plug-in module (see page 2-3).
• Hard drive (see page 2-4).
HP OmniBook 3000

Figure 2-14. Removing the Keyboard

Screw, M2.5×3mm
F1391-60955 (2)
Removal and Replacement 2-17